Tag Archives: Curvature

RC Design Functions 8_03

Posted on 30/04/2019 by dougaj4

The RC Design Functions 8_03 spreadsheet is now available for free download from: RC Design Functions8.zip The main changes are: The NA layer check has been corrected for compression steel in tension The new AS 3600 crack width and curvature … Continue reading →

Posted in Beam Bending, Concrete, Excel, Newton, UDFs, VBA | Tagged , , , , , , , | 11 Comments

Using RC Design Functions – 3

Posted on 08/06/2013 by dougaj4

In the previous post in this series I looked at the results available from the EStress function in the RC Design Functions spreadsheet.  Three associated functions are: EstressCap PLCurve TStiff EStressCap finds the maximum bending moment for a specified axial load, … Continue reading →

Posted in Beam Bending, Concrete, Excel, Newton, UDFs, VBA | Tagged , , , , , , , , | 1 Comment

Reinforced Concrete Moment-Curvature – 1

Posted on 22/11/2009 by dougaj4

The flexural curvature of any beam composed of material with linear elastic behaviour, subject to a bending moment, M, is given by: C = M / EI where E is the elastic modulus of the beam, and I is its … Continue reading →

Posted in Beam Bending, Concrete, Excel, Newton, UDFs, VBA | Tagged , , , , | 5 Comments

Reinforced Concrete Section Analysis – with prestress

Posted on 25/10/2009 by dougaj4

The simplified reinforced concrete section analysis spreadsheet presented here has been revised to allow the input of a pre-tension stress to either or both layers of reinforcement.  The spreadsheet (including full open source code) can be downloaded from RC Design Functions5. Note … Continue reading →

Posted in Beam Bending, Concrete, Excel, Newton, UDFs, VBA | Tagged , , , , , , , , , | 3 Comments