Category Archives: Beam Bending

Stepping through 3DFrame

Posted on 16/09/2017 by dougaj4

Following a recent comment this post looks at the code for setting up the stiffness matrix for a 3D frame, and how to step through any selected part of the code. The general procedure for setting up a 3D stiffness matrix, … Continue reading →

Posted in Beam Bending, Excel, Finite Element Analysis, Frame Analysis, Newton, UDFs, VBA | Tagged , , , , , | Leave a comment

Setting up UDF Applications

Posted on 09/09/2017 by dougaj4

Following a recent comment, this post looks at setting up a user defined function (UDF) on a blank worksheet, using the ConBeamU function as an example. To use a UDF, the VBA code for the function must either be included … Continue reading →

Posted in Arrays, Beam Bending, Excel, Finite Element Analysis, Newton, UDFs, VBA | Tagged , , , , | 2 Comments

Stress increments in prestressed concrete beams

Posted on 02/07/2017 by dougaj4

The two main Australian Standards covering prestressed concrete structures (AS 3600, Concrete Structures, and AS 5100 Part 5, Concrete Bridges) put a limit on the allowable increase in stress in reinforcement and prestressing strands and tendons, when the load increases from … Continue reading →

Posted in Beam Bending, Concrete, Excel, Newton, UDFs, VBA | Tagged , , , , , , | 2 Comments

3DFrame update

Posted on 31/05/2017 by dougaj4

The update to the Glob_to_loc3 and Loc_to_glob3 functions (and associated functions) has now been transferred to the 3DFrame spreadsheet, which will now give correct results when beams are defined in the global negative Z direction.  The revised spreadsheet (including full … Continue reading →

Posted in Beam Bending, Excel, Finite Element Analysis, Frame Analysis, Newton, Strand7, VBA | Tagged , , , , , | 15 Comments

RCInteract and RC Design Functions 7.03

Posted on 09/04/2017 by dougaj4

Since the previous post, I have updated the notes in the RC Design Functions spreadsheet to reflect the fact that with the recent update to the Bridge Design Code (AS 5100) the reinforced concrete strength design requirements for beam bending … Continue reading →

Posted in Beam Bending, Concrete, Excel, Newton, UDFs, VBA | Tagged , , , , , , , , , , | 16 Comments