Tag Archives: Reinforced Concrete

Reinforced Concrete Section Analysis 7 – rectangular sections

Posted on 05/11/2008 by dougaj4

Previous post The spreadsheets presented in earlier posts in this series have been simplified for use with rectangular sections with two layers of reinforcement.  The functions EStress (for elastic analysis of stresses, strains and crack widths) and UMom (for the … Continue reading →

Posted in Beam Bending, Concrete, Newton, UDFs | Tagged , , , , , | 3 Comments

Reinforced Concrete Section Analysis – 6; Ultimate Limit State

Posted on 23/10/2008 by dougaj4

The previous post in this series included Excel User Defined Functions using closed form solutions to find the ultimate bending and axial load capacity of reinforced or prestressed concrete sections of any complex shape defined by rectangular or horizontal layers.  The … Continue reading →

Posted in Beam Bending, Concrete, Newton | Tagged , , , | 6 Comments

Reinforced Concrete Section Analysis – 5; Ultimate Limit State

Posted on 19/08/2008 by dougaj4

Previous posts in this series have looked at the analysis of beams where the steel stress is within the elastic range, and the concrete stress is sufficiently low that the assumption of linear elastic behaviour in compression is a reasonable approximation.  … Continue reading →

Posted in Beam Bending, Excel, UDFs | Tagged , , , , , , , | 5 Comments

Reinforced Concrete Section Analysis – 4

Posted on 21/06/2008 by dougaj4

Previous post The spreadsheet presented in the previous post in this series uses the basic equation given below to find the location of the neutral axis: For a cross section with any applied axial load at eccentricity e, measured from … Continue reading →

Posted in Beam Bending, Excel, Newton, UDFs, Uncategorized | Tagged , , , , | 1 Comment

Reinforced Concrete Section Analysis – 3

Posted on 30/05/2008 by dougaj4

Previous post -1 Previous post -2 The theory presented in the previous 2 posts in this series has been incorporated into an Excel UDF, allowing concrete and reinforcement stresses and strains to be evaluated quickly and easily for reinforced and … Continue reading →

Posted in Beam Bending, Excel, Newton, UDFs | Tagged , , , , , , , , | 8 Comments